Iowa Water Fowlers Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I need to replace the shaft on my mud motor. It seem to be 6ft shaft and at least an inch in diameter with center floating bearing on the out side. They are very difficult to get off as well. the housing itself if not a beavertail or go devil. I am having a hard time finding the manufacturer in order to get the correct replacement shaft. If anyone has any idea on what this could be please let me know.

image008.jpg
 

·
Registered
Joined
·
1,396 Posts
I need to replace the shaft on my mud motor. It seem to be 6ft shaft and at least an inch in diameter with center floating bearing on the out side. They are very difficult to get off as well. the housing itself if not a beavertail or go devil. I am having a hard time finding the manufacturer in order to get the correct replacement shaft. If anyone has any idea on what this could be please let me know.

View attachment 6880
Take the old shaft to a Machine shop, most can make you a new one, for about what a new manufactures shaft cost with shipping. I've had a few made at a local machine shop in my town.
 
1 - 2 of 2 Posts
Top