Iowa Water Fowlers Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello I recently bought at 35 hp carbed vanguard used off a different application and the throttle linkage is all sorts of jacked up. I was wondering if anyone out there with this motor on a mud buddy HD frame could snap some pics of how everything is set up. I am hoping to use the factory squeeze throttle. Any and all help will be appreciated as I am pretty much starting from scratch and can't find any good documents online laying out how it goes together. Attached is some pics of what I have currently going. It starts and goes straight to the rev limiter.
 

·
Registered
Joined
·
1,398 Posts
Hello I recently bought at 35 hp carbed vanguard used off a different application and the throttle linkage is all sorts of jacked up. I was wondering if anyone out there with this motor on a mud buddy HD frame could snap some pics of how everything is set up. I am hoping to use the factory squeeze throttle. Any and all help will be appreciated as I am pretty much starting from scratch and can't find any good documents online laying out how it goes together. Attached is some pics of what I have currently going. It starts and goes straight to the rev limiter.
You are missing a colored spring. It goes where the small dia. spring is in the last pic. One end goes in the ctr. slotted hole the other end where the the small spring is. Small spring isn't needed where its hooked up. Everything else seems to be in the right place. Missing spring can be had at a Briggs lawn mower shop. Spring color should be a purple tint. I think? there are three different colored springs which operate the governor linkage. may want to purchase all three if they are avalible. to be safe.
 
1 - 2 of 2 Posts
Top