Iowa Water Fowlers Forum banner

2005 Ford F-250 XLT 5.4L Cam Shaft Position Sensor Problems

26341 Views 18 Replies 6 Participants Last post by  Steve-O
Anyone know anything about Trucks. I took my truck to Autozone after my check engine light came on, and it came up that my Cam Shaft Position sensor was bad. So my truck has two, I replaced one, and started it turned it on and the light went off, then I took it for a drive and it was fine, but I went to turn around and it quit on me. Then the check engine light came back on, so I switched the one I took out with the other old one, and tried it again thinking only one was bad. And it did the same thing, so are both my sensors bad or is their another problem?

Any input would be appreciated!
1 - 3 of 19 Posts
Ya it could be a number of things wiring problem ecu problem etc etc what was the excact code number if by chance you remember it???
Should be a P0??? something number im thinkin it should be in the P03??'s
Dont see alotta newer fords come through my work but does that 5.4 have VVT (variable valve timing) if so that could cause problems with the cam sensor circuit...
1 - 3 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top